Measure for height and trim on the inside of the drywall or trim at the points where the plantation shutters would be placed. If the drywall or trim narrows further back into the window gap, it’s necessary to think about it. If it does, you’ll want to use the narrower of the two measurements to figure out where your shutters can go. When measuring for inside mounting shutters, make sure you weigh the actual window opening and don’t subtract anything. Since the factory can make the shutters slightly smaller than the measurements you give, accuracy is crucial.click reference here we get info about Plantation Shutters Near Me
You should round down to the nearest 1/16 of a decimal place “. If the measurement is between 3/16″ and 1/4″, for example, round down to 3/16″ “. The shutters would not work if you round up. When ordering, choose the shortest height and narrowest distance. Both diagonal lines, the height vertically from both the left and right sides of the frame as well as the middle, and the width horizontally at the top and bottom of the frame as well as the centre are all necessary measurements.
When mounting shutters on the outside of the frame, there are a few things to keep in mind. Start by determining how much of the area you want the shutter to protect, rather than the window itself. Determine if the shutter frame will be mounted on the drywall, on top of the trim, or on the outside of the trim. Use the same diagonal, vertical, and horizontal approaches as before, but make the beginning and ending points the field to cover the outside. If your shutter will be mounted outside of the trim, make sure your account for the shutter’s clearance from the trim. On outside installing plantation shutters, plantation shutter manufacturers will not take any deductions from your measurements.